Terry is 6'2", seems to work ok for him...
Leg/torso length needs to be considered, too. Getting five drivers to fit correctly in our chump car has been a PITA.
Terry is 6'2", seems to work ok for him...
looks good. Do you have issues with the Watson roll bar's should harness "holders" not really ideally lining up with the shoulder holes in the seat? Mine are a little bit off (my seat is straight) and I'm debating grinding them off.
My buddy has one en route this week for his 2013
I will post pics after its installed.
Evo3 in a s197??? Photos anyone??? Bump. Lol
I can't give exact info for you, but I just installed an Evo2 US (the wide one) in my '14, on a Planted bracket, and there is more room in there. The Evo2 isn't quite wide enough for me in the shoulders but the lower portion fits me fine. To get the height the same as the stock seat all the way down I had to remove the sliders and mount the seat bottomed out in the rear on the side mounts. Maybe the Vorshlag one goes lower but I won't be able to run sliders in the car and fit with a helmet, and I am only 5'10", and I weigh 240lb 34" waist. Not sure on the fitment of the Evo 3 but I think they are for shorter wider drivers, the measurements seemed goofy so I went with the Evo2US.
Hope to have a pic for you soon,
So, my seat instal has been a bit of a disaster, BUT, Finally all is good.
First, bought a used set of Sparcos, brackets, had to raise the seats 1.5 inches,
Then... found out the seats were to narrow, didnt fit me right.
So, ordered a set of Corbeaus from the vendor on the site here...
Corbeau ships me the wrong seats!! Argh...
Finally, got what I ordered, and happy
The driver side is a Wide, passenger is Standard width,
I haven't decided what direction to go yet for harnesses,