What have you done to your mustang today?

[07 procharger]

Sent from my iPhone using Tapatalk while Moonwalking

like your style...I don't know about you, but that install was a PAIN! I don't know if I would do it again.

 

[skwerl]

Brian, where did you get it from?

I got the bumper through Steve at Tasca and had it painted locally. About $3xx for the bumper and $280 for paint.

 

[Newman]

Gonna try to get my car to pass a "normal" inspection. Keep you fingers crossed.

Got it to pass a normal inspection . Do know how It does It, but it does.

 

[LAStang1234]

like your style...I don't know about you, but that install was a PAIN! I don't know if I would do it again.

Wasn't too bad at all. I don't know why they think batteries are 2ft tall though! Have to bend the cable at ridiculous angle for it to connect.


Sent from my iPhone using Tapatalk while Moonwalking

 

[GreenTerror]

Installed my koni yellows, steeda comp springs, strano sway bars and steeda camber plates. It took us about 4 hours total with the mandatory beer brakes and taking our time. Front before to fender 28 1/4" after 27 3/4", rear before 29 3/4" after 27 3/4". I am happy with the stance!

Pictures for your enjoyment

 

[GoneFord]

Wasn't too bad at all. I don't know why they think batteries are 2ft tall though! Have to bend the cable at ridiculous angle for it to connect.


Sent from my iPhone using Tapatalk while Moonwalking

I didn't care for the tight turns you have to coerce the cables into to get them to connect either. But I'm very glad I went with welding cable and not standard battery cable.

 

[JoshK]

Wired up the Reverse Lockout on my TR6060. I don't care what people say about not needing to do it, it is too easy to not do. Also went out and made another log for Manuel.

 

[Onelildude]

Replaced my front and rear rotors and pads. Took about 2 hrs...I'll get pix later when the rain goes away


Sent from my iPhone using Tapatalk

 

[K_Brogoitti]

Trimmed a little off my axle backs cause I didn't enjoy the way they looked sticking so far out of my bumper. Wasted a Lightning stoplight to stoplight... Twice! Shoulda seen the look on that guys face when I dropped the clutch at 6 grand doing 30. My long tubes sounds SICK!

Sent from my XT1080 using Tapatalk

 

[LAStang1234]

Sent from my iPhone using Tapatalk while Moonwalking

 

[stang8psi]

Aluminum ds, lower control arms..new wheels.. funny the rear end moved to the right (pass side) some after the control arms.. wonder why.. now I have to adjust the pan hard bar.. haven't had to adjust it.. haven't had to un 3 years Lol
.

 

[jayman33]

Sent from my iPhone using Tapatalk while Moonwalking

Ah snap! Getting ready for some upcoming events?

 

[black06gt3v]

ordered subframe connects and getting a kellogg crankshaft

 

[LAStang1234]

Ah snap! Getting ready for some upcoming events?

Yea, Summer lol!


Sent from my iPhone using Tapatalk while Moonwalking

 

[Scott]

Looks good! I installed the same Taylor box over two years ago and just got around to cutting the hold down rods to proper length a week ago.

 

[LAStang1234]

Looks good! I installed the same Taylor box over two years ago and just got around to cutting the hold down rods to proper length a week ago.

Scott, where did you ground the battery at?

Would this be a good spot to use as a ground in the trunk?

Sent from my iPhone using Tapatalk while Moonwalking

 

[doogie]

Finally got is out of the garage, but the battery is shot... So I need to grab a new one before the first real drive of the season... Which can't be soon enough!

 

[fnfast]

Installed my eibach pro kit and Steeda caster camber plates on my koni yellows and added new SVE drifts.

 

[o2sys]

Started my retrofit:

 

[AnotherS197GT]

Swapped my summer wheels back on, greased my brake slide pins, and discovered a huge pinion seal leak. Ordering 4.10s and a T-Lok rebuild this week. What has me worried though is idk if its because its got 110k, or because its been lowered on a stock UCA for a year.