Search results for query: *

I’m looking to see if there’s anyone in or around the Los Angeles that would be willing to rent out or allow me to use their SC pulley removal/installation tool for my 2008 GT500 I don’t mind if I have use the tool at your place of residence to insure the tool is not stolen or damaged... I just...

Ok I’m picking up a used metco pulley for my 08 GT500 today but the seller doesn’t have a removal tool and neither do I. So it’s up to me to pull the Metco from his Eaton. If I resorted to renting a pulley puller and installer tool from autozone, which type should I rent cause there’s a few to...

is it normal to hear a boost or vacuum bleed off sound as I’m moving the gt500 around the driveway? I’ll hear this swooshing sound while crawling forward in 1st gear and while reversing.

hey guys, I’m going to look at a 08 GT500 with 6 speed manual tran and 41,000 miles... Is there anything I should pay particular attention too? Any Areas that are prone to failure?

Hey guys, I’m getting gas cap warnings on my dash. And usually after just starting the car after letting it sit for an hour or more, I’ll have a misfire and stumbling acceleration at 2500-3000 rpms that gradually goes away about 1/4 mike down the road. Not to mention the p0148 p0316 p0457 codes...

Ok on and off for the past year my 2005 GT has suffered from the periodic combination of P0443, P0446’s and other times a combination of Evap system small leak detected, large leak detected and check gas cap. So I’m fabricating a smoke device out of a paint can, Incense and some hoses to help...

I found a decent deal on some hotrod cams. Used of course. They come in the box but you know, I’d like to be sure.

Hey guys, the problem I’m having is that once I’ve been driving for about 45 minutes, my car will stall and take about a minute to start back up. The stall is sudden with no hesitation or lumpy idle before, just off suddenly like the key was turned off. I datalogged and got lucky and a...

I’ll start by mentioning, I know that if I have to recharge the ac system with Freon, I know I have a leak, I know I should have a ac tech diagnose it, I know it’ll eventually leak out and I also know that stopleak could damage components of my ac system which could cost me more money to repair...

Ok I have an 05 GT with a Manual transmission and someone locally is selling there stock driveshaft from an 07 GT with Automatic transmission... Will this 07 GT autotrans Driveshaft fit my 05 GT manual trans vehicle?

Id like to squeeze alittle more power out of my 05 GT, I'm using a diablo Predator on a 91 octane tune designed for my JLT v3 cai, no cats. My adjustable perimeters are as follows: Dual timing adjustment points (2000-4000 RPM / 4000-7000 RPM) Timing table (+10% / -40%) Dual fuel...

I had AmericanMuscle.com price match the price on the BMR Rear Lower Control Arms against the price Summit Racing was selling them for, they are now $76.46 for the pair with free shipping on AmericanMuscle.com

05 GT 5 Speed, So I replaced my rear trans seal or output shaft seal, I've noticed it leaks still and haven't taken the time to slap in another seal but today I used my phone to get video of the top of the trans... more specifically the gear selector. Watch the video, let me know if you would...

Is it possible, If I install some Hot Rod cams and drive around a few hundred miles (Freeway/Street) without a tune for the Cams... Will my 05 GT survive or even run well? I got the unfortunate news that my handheld tuner manufacturer cannot provide me a tune to accommodate the use of Hot...

Ok, quick bio... 2005 GT,5 speed Manual trans, stock except for JLT CAI and Diablo Tune. Ok is it normal to hear a loud single "thump" coming from the engine bay the moment in press the clutch in when shifting from 1st to 2nd gear at WOT. Ex: in 1st gear, WOT, 6000 RPM - Presses clutch...

Im looking for someone in or around the Los Angeles area today who has a set of Off Road H/X-pipes that I could pick up tonite. Anyone that fits that criteria, please text or call me 626-283-0419 CJ. Thanks for a 2005 Mustang GT 3v engine.

Looking for a set of lightly used or new GT500 Strut Mounts. Looking to spend under $100 shipped.

Like many others, I covet and desire a set of Ford Racing Hot Rod cams for my 05 Mustang GT. I live in Los Angeles Ca and will someone please take my $500 dollars and ship me a set of Hot Rod Cams.

Hey Guys, issue I'm having is once the car is warmed up, my interior floor boards and center console radiate so much f-ing heat! Does anyone here have this problem and know where to look as far as stopping this from happening? Aside from this being uncomfortable, it's also causing my clutch...

ok I installed my Stingers afew weeks ago, maybe a month ago. How far up does the the inlet on the axle back have to go on the exhaust pipe that connects to it? On my driver side axle back, i noticed i couldnt get that small circle tab on the stock pipe to go very deep into the channel of...

Hey guys, I found an awesome deal on a used Unmarried DiabloSport Predator U7140, I want to know if any of you guys know of any pros and cons with this model Tuner. I'm going to use it on my 05 GT, only upgrades I have at this moment are a set of Ford Racing Stingers. In the future I plan...

Edit: forgot to mention I have an 05 GT manual trans. Hey guys I've searched all over this forum and i only found solutions that always lead to purchasing a tune to solve this issue, but I haven't found any definitive repair that does not require a tune to fix this issue. I'm wondering if...

I'm so freaken excited and anxious to install a set of Ford Racing Stingers I picked up lastnite! 10 minutes before I got out of work, I checked craigslist for used parts and BOOM... Someone was selling a set of Stingers for 350 Obo, I offered $250, he countered with $270. 40 minutes later...

I need your help guys. I searched and couldn't find a definitive answer for all my codes I've got, I have 2 evap codes and all 4 o2 heater circuit codes. P0443 P0456 And o2s P0135 P0141 P0155 P0161 Any help as to what is causing all this would be greatly appreciated.

Well I replaced both my phasers Wednesday, one had a broken pin that held part of the spring up while the other phaser looked ok, replaced them both and everything went well, she started up and ran smoother and was quiet/no phaser tap. And Friday on my way home from work, the CEL lit up and...