Boost tap location

[06JET]

I would like to know the best location for the Lund Boost sensor to be hooked into. Procharger says that the brake booster line is the recommended location. From experience, do you agree? I want to see the intake pressure after the throttle body. I have a Ford Racing Intake. I don't know if that would matter. I've looked for a post with recommendations but could not find one.

 

[swflastang05]

The brake booster line would work fine IMO, However I use the smaller port at the DS front of the FRPP intake, right behind the TB. I don't remember what that port is normally intended for, but whatever it is I wasn't using it so I connected it for boost/vacuum instead.

 

[JUSTA3V]

I believe that's the pcv sucker port thingy.

 

[06JET]

Thanks for the input. I thought about using that one but I wasn't sure.

 

[05stroker]

They all come from the same atmosphere in the intake. Just pick one that is close to your needs.

 

[JeremyH]

Like said multiple ways to do it, just need a boost/vac source off the intake manifold. Most use the vac line going to the frps.

 

[06JET]

OK, thanks guys. That is where my hose is tapped into for my Procharger BOV. I think I will tap it into my brake booster line instead of adding another one into the frps line.