Need Help with fail safe mode.

[RogersBlue05GT]

Will yesterday I pulled my spark plugs to gap them to .035 and I took my throttle body off to get to the plugs under there. My stang has a whipple HO on it. Once I finished with all the plugs I had the car back together and went to start it and it went to failsafe mode and I checked the codes and it was the TPS so I replaced it and cleared the codes and tried to start it and the failsafe came back up and with the same codes for the TPS.

How can I fix this without taking it in to the dealership to get it fixed?

 

[JeremyH]

Why would you remove the throttle body to pull spark plugs?
Anyways disconnect the battery and make sure everythings hooked up all the senors plugged in. Let sit for 5-10 minutes then reconnect the battery and start her up. This should fix the problem unless u damage the tps somehow.

 

[RogersBlue05GT]

I have a Whipple HO on my car and the Throttle body sets right over two of the plugs that is why I removed it. Plus I have disconnected the battery for over an hour and it still didn't work. I have replace the TPS so I know I didn't damage it.

 

[Toy4Bob]

I have a Whipple HO on my car and the Throttle body sets right over two of the plugs that is why I removed it. Plus I have disconnected the battery for over an hour and it still didn't work. I have replace the TPS so I know I didn't damage it.

Hmmm, was going to suggest the TPS, as that is what happened to me.

 

[JeremyH]

I have a Whipple HO on my car and the Throttle body sets right over two of the plugs that is why I removed it. Plus I have disconnected the battery for over an hour and it still didn't work. I have replace the TPS so I know I didn't damage it.

Oh gotcha

 

[JeremyH]

If you replaced the TPS the voltage might be off i dunno what else it could be.