Steeda upper control arm question

[MattD]

I installed my Steeda competition adjustable upper control arm last night and I have a question/concern.

I am hearing a bumping noise under hard acceleration/deceleration. Is this just the movement of the heim joint or what?

I'm pretty sure the pinion angle was set up correctly.

 

[Kevin@PMP]

Did you set the length to stock? I only hear mine when going over bumps slowly. Also did you torque all of the UCA mount bolts?

 

[MattD]

All of the bolts were torqued to spec and I went by Steeda's recommended length on the arm to start out with. I think I need to tighten the locks more on the arm itself, because it gets worse as you drive it.

Do you know the torque specs off hand so I can recheck them personally?

 

[A&B 06GT]

Hey i would like to know ask well as im about to install the same part