mustang gt

So I pulled the trigger. Bought the cx racing kit. considering the extra parts that come with it and the slightly better build quality it was worth it to me. along with the complete/ full kit from cx racing here is the list of things I have come up with that will be needing to be ordered. Ford...

Looking for tips of your supercharger install! Any special things you did that weren’t in the instruction manual? Any videos out there that are very helpful?

I recently purchased the Paxton Novi 1200 Supercharger for 2006 Mustang GT. Who has experience with this system? I would like to know if there's anything else I should add to it for best performance or is a must have for the build? Here's what's included in the system. NOVI 1200SL gear...

Greetings everyone! So I just received my 2015 Mustang GT PP back from the dealership after a wheel alignment, all new spark plugs and most importantly, my motor replaced (old one had a cylinder 8 misfire with no recourse of fixing). Strangely enough, the car “wobbles” when accelerating at...

I have single turbo on my 2011 mustang gt and when I turn the car on and starts to warm up a bit the ignition switch feed fuse keeps popping any ideas why it happens i dont have the tune for the turbo i just installed it so dont know if its that it draws too much power or what

Hello all, I just joined forums and have a dream of swapping my v6 s197 with a 7.3 Godzilla. I plan to start saving/budgeting now and would like to start beginning of 2022. However, I am very new to mods, especially swaps but I want to learn how along the way and do as much as I can on my own...

Hello Thread, (This will be TLDR because it has to be for the help I need.) I am new to the forums but have been looking through them for days not seeming to find anyone with my exact issue. Let me start off by explaining what the cause of my replacement was. I own a 2011 Ford Mustang GT 5.0...

Hey guys I’m new to this forum! I own a 2011 mustang gt and it looks too stock for me and the outside so I could use some suggestions on what else to put on her to make her bad... lmk pls

Hello I have a 06 mustang gt. I installed 42ibs injectors I ran a few premade tunes from my SCT X4. Ever since I did that I've been popping a P060c code and has been stuck in limp mode. I can't revert back to stock with the injectors or I'll drown the engine. I have no idea how to fix this...

I've wanted a fox body for a long time. The first Mustang I ever rode in was a fox body. The first Mustang I ever drove was a fox body. I’ve been a huge fan of these cars since I was a teenager and always wanted to own one. I also wanted a project car that I could tinker with and build up and...

Hello to all. Just finish rebuild of tr3650. Now I have a small prpblem two os the snap rings broke and I replaced with a similar one but not so think like original one. So can this be a big problem later on or it can go like that??? Thank you...

Hey guys sorry if im repeating a thread but i have not found help on this anywhere! Ive had other mustangs that ive had issues w/ a throwout bearing or similar but I need help with this particular situation! I have a 2011 Mustang GT with an MT-82 at 108K miles. I did the tranny oil change at...

So I'm debating between getting a JLT series 3 or an Airaid Race Mxp series CAI. Both have good gains but according to American Muscle, the Airaid is said to have more Torque gain (low end) and good HP gain. What is your guys opinion on the best intake paired with a 62mm Throttle body?

Hey guys, I recently signed up here as a member but I've been using the site for about 2 years for various things. I've had my 06 Mustang GT 4.6L for about 2 1/2 years and I'm just looking for some advice and tips on modifications. I don't want to miss any details whenever I start adding mods...

I have a 2013 Mustang V6 Base. My windshield wipers will automatically go on once I start my car even with them being turned off.!! I pulled the fuse out until I can find out what my problem is. I have been doing some research online and still cannot tell. I was going to start by replacing my...

Hello Everyone, This is my first post here, haven't been active on any forums in years. Some background: I'm a mechanical engineer and self taught fabricator. Previous car was a 240SX that I swapped in an SR20det, painted a couple times, etc. More recently I bought a wrecked 06 mustang. First...

Car info- mutha thumbr cams, cai, x pipe, mufflers, bama tuned, Ford Racing lowering springs. While driving the car normally shifts under 3-3500k it shifts smooth and as fast as you can change them. Then at the track or goofing off shifts above probably 4K it’s super stiff and asks like it’s...

Okay I have a 2010 Mustang Gt, xpipe, pypes mufflers, steeda cai, mutha thumbr cams, bama email tune. The car runs decent, not what I expected after the cams, I thought I would be able to feel some more power on the butt dyno. Besides that the bigger problem is while driving and changing gears...

I installed comp cams and phaser limiters and then uploaded the bama tune. I have a cai and x pipe/ axle back, now the car runs like complete crap, absolutely no power, runs rough and is jumpy at low speeds and can’t idle at one rpm. Is this the tune? Or do I need to take it to a real shop for a...

Hey guys/girls This is my first post but I plan to be here awhile. I decided to take the plunge and buy a salvage title car (relatively minor damage) and repair it. I'm documenting the whole build on my YouTube channel. I figure I would go to the knowledgable people and ask questions as they...