Brembo 4 piston Logo Dimensions

[Count]

Hey All,

I'm planning on powder coating a set of 4 piston brembos that no longer have the logo on them. I'm debating whether i should just make a vinyl decal with my cutter or perhaps make a stencil and paint them on, I haven't decided on which way to go yet.

I was hoping someone with a set could let me know what the height or width of the logo is? I only need one side.

 

[UltraKla$$ic]

I have an extra set of vinyl stickers but I'm not at home right now. I can measure later this afternoon if you haven't gotten a reply by then.

 

[Department Of Boost]

Hard to measure through the wheel but I'm getting 2.56" across on a 2012 OEM Brembo caliper.

 

[Count]

Hard to measure through the wheel but I'm getting 2.56" across on a 2012 OEM Brembo caliper.

Awesome! Thanks a bunch!

 

[UltraKla$$ic]

 

[Department Of Boost]

Those are a lot bigger than the 2012 calipers. I like em.

 

[Count]

I'm definitely liking these larger dimensions. I cut a bunch of the smaller ones and what a pain it was to weed that vinyl. I'm cutting a few now to compare...

Thanks for checking on the size!

 

[Paul.]

I have a couple sets of stencils leftover from painting my brakes. I have them for both 4-piston ones, and the larger 6-piston ones. I can sell 'em to you if you like. They're not doing me any good and I don't have any more brakes to paint right now.

Paul.

 

[Count]

I'm surprised by the disparity in sizes between the 2...hmm

 

[Count]

I have a couple sets of stencils leftover from painting my brakes. I have them for both 4-piston ones, and the larger 6-piston ones. I can sell 'em to you if you like. They're not doing me any good and I don't have any more brakes to paint right now.

Paul.

Hey Paul, Thanks for the offer but I just created a few out of vinyl myself. These should work.

 

[Count]

I'm surprised by the disparity in sizes between the 2...hmm

Duh!! 4 vs 6...lol