What have you done to your mustang today?

[Martin]

tried that as well, but it was crumpled beyond recognition by my pressure washer

 

[diambo4life]

I just swapped out 2-piece OEM driveshaft for a 1-piece....

I did as well when I went to a T56. What brand?

 

[MADGT]

Went with: Ford Performance 3.50-Inch Aluminum One-Piece Driveshaft

 

[Martin]

I took off the valve covers to see what's inside. now I know, there are .....stuff.

 

[Gladams]

Now who would have put all that go fast stuff in there?

 

[Martin]

Changing colours.

 

[diambo4life]

Did quite a few things this past week.
New O2 sensors
New spark plugs (NGK 6510s) and regapped
New splash shield
Bled my brakes
Changed the oil
Flushed the water out and added antifreeze.
Replaced some of the worm clamps with tbolt clamps on my charge pipes
Cleaned the car

Looks and drives amazing now.

 

[MasterofDisaster]

Last Sun changed the oil, greased the bushings, & upgraded the front sway bar bushings to polyurethane. Very easy swap. Just don't let the bar swing down and remove your teeth.

 

[Dino Dino Bambino]

Made some improvements to the heat shield of my JLT 3 CAI to ensure it's properly sealed from the hot engine compartment.

Before:


After:

Trimmed some excess material from the bottom, added some extra material at the bottom of the back wall, and created a new floor.

As installed:

I added thicker foam trim along the top so that it seals properly against the hood (the original rubber weatherstrip was inadequate and left a 1" gap in places). I also sealed the gap between the pipe and heat shield.
Now it performs like a proper cold air intake!

 

[Martin]

Freshly powder coated. So purdy!

 

[Martin]

And they’re in

 

[86GT351]

Going to a drag look with Mickey Thompsons all around

 

[JC SSP]

What size are they?

 

[Shane361]

Finally got my 21 Mustang on Ford Pass with my Truck...lol. Love the auto start temp control, tracking, gas and all the other shit you can do. Although it looks like I may need to drive it to update.

 

[86GT351]

What size are they?

The tires are Mickey Thompson 26 x 6 x17 Sportsman SR and the backs are 275/50/15 Mickey Thompson ET Street SS. They are going on these:

 

[JC SSP]

Ok I could see the tire decal that the front skinny’s were 17” but could not see the rear.

Beautiful rims and those fat meats will look and hook great on the fox!

 

[86GT351]

Ok I could see the tire decal that the front skinny’s were 17” but could not see the rear.

Beautiful rims and those fat meats will look and hook great on the fox!

Along with the fully adjustable UPR Rear Suspension.

 

[Martin]

Removed a broken valve cover bolt. Don't ask

 

[Recon]

Before shot.

After.
Found some decent shape 18in coyote wheels. Just temporary until the wheels I want are back in stock. Funny thing is I like the original wheels better.

 

[WJBertrand]

Washed, clay barred, polished and ceramic coated, then won 1st place in my category at the Ponies by the Sea Mustang show today!