s197

  1. W

    WTB: Used ModdBox 4.0L V6 M90 Installation Plates / Adapter

    Hey everyone, I'm building a budget Eaton M90 setup on my 2006 4.0L V6 Mustang. Since I don't have a welder, I'm looking to buy a used set of ModdBox top and bottom plenum adaptation plates. If you have a set sitting on your garage shelf from an old build or a part-out, please PM me with your...
  2. J

    Rhythmic knocking / rubbing noise under load – 6R80 Mustang V6 2012

    Hey guys, I've got a 2012 Mustang V6 (3.7, automatic 6R80) and I'm trying to track down a rhythmic knocking / rubbing noise that happens only under acceleration (load). Here are the symptoms: The sound is most noticeable around 3,000 RPM under moderate throttle. The engine itself runs...
  3. A

    Mustang Rebuild

    Hey, I’m in need of some serious help, I bought a Mustang Gt 2010 Premium, 4.6L 5 speed auto, had it for 3 days and had a serious front end collision with a concrete barrier, it was a hit and run and insurance won’t cover it, sucks like hell because I spent a shit ton of time looking for the...
  4. N

    Rear piston seal leak

    2007 gt mustang with powerstop z23 evolution brake kit. Passenger rear was leaking bad from the ebrake bolt on the caliper so i replaced it with an oem one and both rear rotors and pads. Bled the whole system and made sure there were no bubbles in the hose. Went for a little test drive and...
  5. N

    2007 gt mustang powerstop z23 rear caliper rebuild

    Rebuilding passenger rear caliper due to actuater adjuster bolt seal leak ( parking brake bolt thay pushes piston in) The rebuild kit comes with a bigger seal that has a hard un squishable surface so i cant get it in the hole leading me to believe they used different seals. The seal part is...
  6. W

    2011-2014 FORSCAN / AS-built spreadsheet???

    Hello, I am currently looking for the FORscan spreadsheet, also known as the AS-built options, for 2011 and newer Mustangs. I found links related to the 2011-2014 F150s and S550, but it seems there aren't any postings regarding S197 programmable codes. I am trying to disable the Daytime Running...
  7. J

    high fan is always on

    Recientemente adquirí un v6 2013 con algunas fallas, nada grave excepto esto, el ventilador de alta siempre está activo y el de baja no, ya revise el cableado y parece estar bien, ya cambie los relevadores, el ect no lo cambien porque si lee en forscan, aun así no se si descartarlo, código p0645...
  8. 8

    Idle tick while revving up to 1900 rpm

    my gt/cs has a small tick and I'm wondering if its something small or if I I need to be worried.. it just doesn't sound like it's crazy bad but I park in a parking garage so I hear it everyday after I hop off the interstate..it really won’t do it when it’s not been driven but when I hit the...
  9. A

    4.6 3V Swap from 05-09 Explorer/Mountaineer/F-150

    I currently daily a 2007 Mustang GT that has begun experiencing a bad knock from main/rod bearings. The cheapest option is currently a used motor. I wanted another mustang motor, but they are way too expensive in comparison to the 4.6 3V from the 05-09 Explorer/Mountaineer/F-150. I am not...
  10. Jay El

    2014 s197 3.7 auto tranny to driveshaft slip yoke wobble

    What parts would you guys change? Could both sides of the slip connection be worn out too far and require replacing? There's visible oil wetness around the seal. The car swings back and forth if the accelerator is released at medium to high acceleration and a clunking can be heard.
  11. WasabiWarlord

    Issues w/ Speakers

    I've inherited my dad's old 2014 Mustang 3.7L Premium, and I'm trying to return the audio system back to stock after a sketchy install my dad was fleeced $2500 out of for. I've removed everything to include the aftermarket amplifiers, head unit, dash kit w/ AC controls, and related wiring. I...
  12. Redbone3v

    2010 Mustang GT Tranny/Rear Diff noises

    Hey all, about 3-4 months ago I purchased a 2010 3v manual and the problems only but started. The rear diff started a nasty whistle, (I'm gonna call it the "kindergartener's musical recorder flute") only when I am using the gas pedal, and as I let off the second I let off it goes away and theres...
  13. Jack Wallace

    Ground/wiring locations

    Hey guys! Currently in the process of restoring a 2007 Mustang GT. I’m redoing a lot of the factory wiring as some of it is damaged or just looks dingy and I’ve got a couple questions about the grounds. I’ve relocated the battery to the trunk, so I will be relocating all of the grounds (all 2...
  14. R

    Drag racing experience - 15 or 17 inch rear wheels?

    Hello Everyone, I am a new member, but I have owned my 2012 GT Premium since June of 2011. I ordered the car with the 3:73 rear end and the MT82. I have enjoyed the car for years on the street, but I want to spend some time running at "Test & Tune" events, AKA "Street Nights" at New England...
  15. Dusty13GT

    ‘13 ambient temperature sensor wiring

    Hello, pretty new here but I’m trying to track down my ambient temperature sensor because my EXT temp constantly reads 50* outside. I know where the sensor/wiring SHOULD be but mine is not connected to the horn wiring like I’ve found on diagrams and seen on videos. My harness at the horn also...
  16. ThatOneS197UKnow

    Bent Clutch Pedal + clutch/brake issues ‘12 GT

    I just recently purchased a 2012 Ford Mustang GT Premium, it has come with a multitude of issues. One of which being the clutch pedal being crooked to the left, which I believe could be causing the issues i will now state. Whenever I shift at high RPM’s, the clutch pedal will stick to the...
  17. RepulsiveReject

    Retrofit ideas from late S197 into early S197?

    Hey everyone! New to the forums here! BEFORE ANYTHING: If you love the early S197 interior, don’t read! :p I love the interior of the 2010-2014 mustang, and have wondered just how many things are replaceable/adjustable to install in my ‘07. So far, Ive got the steering wheel and that’s about...
  18. CORN

    Western Motorsports Intake

    I was wondering if anyone has the Western Motorsports Intake or at least had at one point. What's your opinion on it, is it worth getting an air ram style hood for? Also they no longer sell the whole kit, I emailed them and they responded by telling me there's about 50 pieces to this kit. I'm...
  19. A

    2011 coyote vmp supercharged NO IGNITION SPARK

    Got an 11’ finally put back together, built motor gen2 block, t56 swap with bowler harness, vmp supercharged, fore innovations triple pump . Car cranks over, throws fuel but no ignition spark, checked all grounds, changed wiring harness, changed to new coils, new plugs, had pcm reflashed...
    • Alexmaya07
    • Thread
    • coyote 5.0 no ignition spark coyote no spark ford coyote no ignition spark ford coyote no spark s197 vmp supercharged no igniton spark
    • Replies: 39
    • Forum: 2011+ Mustang GT 5.0L Tech
  20. T

    Parnelli Jones style rear bumper

    I'm looking for a Parnelli Jones or Saleen style rear bumper or some way to fill in the emptiness of where the license plate is supposed to go. What I'm doing is I'm buying the Saleen decklid panel so that my license plate can go there. It should look like this
  21. R

    CEL P0402

    2006 V6 I had a light for this code for a pretty long time. I want to sell the mustang now and want to get rid of it since people usually don't like to hear "don't worry about it" about a check engine light. So I used my scanner and got P0401 (EGR flow insufficient) and P0402 (EGR flow...
  22. kona_302R

    Does anyone know what part this is on an S197?

    Hello everyone, ever since I got my 2011 GT I have been wondering what this plastic/metal box was on the underside of my car, right below the spare wheel well (pic related) Anyways I was wondering if I could replace it with a less bulky cover because it protrudes into view with the aftermarket...
  23. Jordan

    BOV Placement

    Any specifics on BOV placement? Close to finishing my supercharger install and I’m about to install the BOV. Heard of placement between SC and IC. And also heard of placement between TB and IC. What have you done?
    • Jordan
    • Thread
    • 2006 blow off valve boost bov paxton s197 supercharged supercharger vortech
    • Replies: 2
    • Forum: Mustang Chit Chat
  24. Andrey Sidorov

    S550- 6 piston Brembos on 05-14 GT Guide (affordable)

    Hey fellas, i think it is not a surprise to anyone that stock s197 brakes are as* to say the least. So if you were thinking about upgrading your stock brakes to something better and not sell your kidney in the process or your calipers got bad and you need a replacement or rebuild - this will be...
  25. Jordan

    Supercharger install information

    Looking for tips of your supercharger install! Any special things you did that weren’t in the instruction manual? Any videos out there that are very helpful?

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top