BeachMonkey100
forum member
Nah - Speedo sensor O-ring - It's just weeping a bit of fluid. I know it can be done in-car.
Does the tailshaft have to come off to do those two rear seals or could they be done in car?
oh okay, I miss read what you were saying. That certainly can be done in the car lol.
and the two rear seals can be done in the car I don't see why not, you don't have to pull the housing as both the seals are accessible, but will need to pull the flange first, the only problem is (in my mind) finding something large enough to fit over the end of the tail shaft and still wide enough to install the tailhousing seal which I have but obviously that doesn't help you. Other than that it's doable, I would drain the fluid while you're at it to to prevent any mess. and the flange seal is deceiving while installing, put the flange on with the nut and washer first, run down the flange with the bolt, remove the washer with a magnet then put a light film of grease on the seal then slide it over the tail shaft, reinstall the washer and bolt, not doing so you risk tearing up that flange seal pretty bad matter of fact you risk shredding it to pieces by putting it on then running the nut down with an impact.