How hard can you launch these cars?

[one.wicked.stang]

You can wire them to use in an Auto as well, little longer install because you have to add a switch.

 

[Wicked97]

How Hard? Hard enough to capture 1.3 Sixty foots, N/A.

http://www.youtube.com/watch?v=ML1KZEUhn0Y

ha ha

I was going to post that video and this one

 

[schuhanks5.0]

that silver car is RAD!

 

[Falkinman]

Holy crap, yeah that silver car is quick!

 

[marcspaz]

I've seen that one in person. It is bad ass.

 

[2DaDarkZide PR]

I'm curious how hard everyone is launching their manual trans cars.
What RPM have you left the line at?
What tires are you using?
What gears?
What modifications?
What's your best or average sixty foot times?

My best sixty foot so far is 1.80 with 3.73 gears, stock tune and M+H 28X9 drag radials Left the line at approximately 4,500RPM with 32psi, didn't heat the tires and the tires stuck hard.

My best is a 1.812 60' with 275 nitto 555 STREET tires launching at 5500RPM.

 

[HellsBells]

I don't know how you guys pull off the 5000+ RPM launches.

i went 1.799 60' launching at 3000 RPM. NT555R drag radials.

 

[fdjizm]

^fuckin cheater.

 

[HellsBells]

^fuckin cheater.

I've done the simulations ok????

 

[cm581978]

I bet Al O. thinks the zl1 will cut a 1.5 60 ft

 

[marcspaz]

I've done the simulations ok????

http://www.rbracing-rsr.com/nhraxtreepro.html

 

[HellsBells]

http://www.rbracing-rsr.com/nhraxtreepro.html

Dude........I suck.

 

[marcspaz]

LOL The trick is to click the button and hold it down, so that way your reaction time is only the release of the button instead of having to press than release the button.

 

[HellsBells]

LOL The trick is to click the button and hold it down, so that way your reaction time is only the release of the button instead of having to press than release the button.

BRB, installing a mouse in my car.

 

[Marc s]

6200 RPM's on the two step, 60's in the 1.40's with stock axles.

 

[itsslow06]

Spectre cai, o/r h, slp axlebacks, and 93 bama tune and I launch it between 4000-5500 and cut a 1.9 60' with the stock tires and full weight and a lot of tools in the trunk....

Sent from the drag strip!

 

[fdjizm]

http://www.rbracing-rsr.com/nhraxtreepro.html

Pfft... cake...

Dude........I suck.

That's what cheaters get, bro

 

[HellsBells]

Pfft... cake...

That's what cheaters get, bro

I don't cheat

 

[skwerl]

This was about 4000 rpm with an Exedy Mach 500 clutch and stock 3650 trans.

 

[Blackbird1084]

Nice pic!