Maybe the cheapest Roll Bar?

[MexGT]

Anyone have tried this?

http://shop.brokedickracing.com/05-09-MUSTANG_c_2860.html

$400 for a chromemoly 6 pt roll bar (No swingouts)


and $200 for a mild steel?

can prices really go that low?

 

[94tbird]

too good to be true

funny thing is if you break down their web address you get

http://shop. broke dick racing .com


hahaha broke dick racing lol

 

[MexGT]

hahahaha didnt saw it that way lol

eitherway, the swingout conversion is $45

 

[US-1]

You are joking......right?

 

[MexGT]

huh?

 

[don_w]

the swingout conversion is $45

For the roll bar, or for the Broke Dick?

 

[08StangGT_CS]

http://www.swracecars.com/store/8-Point-Roll-Bar-OSCARItem_259=11-3074.aspx

Another cheap roll bar that I found. Not that I'm going to buy it.

 

[gijosh28]

http://www.swracecars.com/store/8-Point-Roll-Bar-OSCARItem_259=11-3074.aspx

Another cheap roll bar that I found. Not that I'm going to buy it.

$170?! can that be real? someone needs to buy this to try it out.

 

[94tbird]

$170?! can that be real? someone needs to buy this to try it out.

I volunteer you

 

[MexGT]

Well that makes the $399 chrome moly roll bar more believable lol

 

[94tbird]

the bars are probably paper thin and wont meet NHRA standards by any means

 

[retfr8flyr]

Actually I had an S&W kit in my old 96 Vert. The kits are so cheap because the only bent bar is the main hoop and it didn't fit that well. Everything else is just a cut piece of straight pipe without any end notching. The mounting plates all have to be heated and formed to weld them in. It is fairly big job installing one of these it's not like the MM or Wolf kit.


Earl

 

[MexGT]

the bars are probably paper thin and wont meet NHRA standards by any means

Well their website says ... (copied from there)
6-POINT ROLL BARS Made from either 1-3/4"x.134" wall mild steel (EWS) tubing, 1-3/4"x.134" wall DOM (Seamless) tubing, or 1-3/4”x.083 Chromoly (4130) Tubing

And in the 2008 NHRA Rule Book at page 42 or 4:10 it says:
http://www.moddedmustangs.com/forums/drag/90720-nhra-rule-book-pdf.html

All materials must be 1 3/4" O.D. x .118" mild steel or .083" 4130 chrome moly tubing

So far IMO its legal and cheap, and their mild steel is a tad thicker than the required by rule

 

[Freaknazty]

jegs sells a similar kit for like 170 also ..... billy "05stroker" has one in his

 

[MexGT]

I'm definitely getting the $399 chromemoly one + $45 to make the swingouts!

just... er .... my wallet needs some rest haha

 

[05stroker]

jegs sells a similar kit for like 170 also ..... billy "05stroker" has one in his

Yep and soon I will order that Jegster 10 pt upgrade and cut and fit and weld and have a 10 pt for less then the $399 kit up there a few post . Really just depends on how much work you want to do.